Mil-Spec and ISO Certified Adhesive Solutions and Approvals

Here is a list of Hernon Products with assigned CID numbers

Dear valued Hernon customer, please be advised that Hernon Manufacturing, Inc. is registered to ISO 9001:2008. As such, we are in full compliance with the requirements of the ISO 9001:2008 standard. A copy of our registration certificate is attached below.

Many Hernon® products meet or exceed the standardized objectives set by the U.S. Department of Defense. These objectives are known as military standard, mil specs, or “MIL-STD”. Please consult Hernon Customer Service for more information about test reports and certificates of conformance needs.

SILASTOMERS 333, 334, 336: When fully cured and washed, Silastomers 333, 334 and 336 meet the requirements of FDA Regulation No. 21 CFR 175.105 subject to and use compliance with any applicable total extractives limitations. Hernon 317, Two-Part Epoxy: Cured coating formulated with Hernon 317 epoxy resins, crosslinking agents and adjuncts may be safely used as food-contact surfaces and conform to listing in section 175.300, Title 21 (21 CFR 175.105) of the Code of Federal Regulations. The cured Hernon 317 epoxy coating may be applied over a metal or other suitable substrate as a continuous film that serves as a functional barrier between food and the substrate. Please review the regulations.

DripStops 920, 940; Nuts N' Bolts 427; Self Sealers 604, 615, 616, 618: Grade numbers DripStop 920, 940, Nuts n' Bolts 427, and Self Sealer 604, 615, 616 and 618 have been tested and classified by Underwriters Laboratories Inc. as to fire hazard only: Fire hazard is small; No flash point in liquid state; Ignition temperature 837°F (447°C). Suitable for use in devices handling gasoline, petroleum oils, natural gas (pressures not to exceed 300 psig), propane, and butane. 29R9 Reference: Underwriters laboratory File Number MH14222.

SILASTOMERS 333, 334, 336 (FDA COMPLIANT): When fully cured and washed, Silastomers 333, 334 and 336 meet the requirements of FDA Regulation No. 21 CFR 175.105 subject to and use compliance with any applicable total extractives limitations. Hernon 317, Two-Part Epoxy (FDA COMPLIANT): Cured coating formulated with Hernon 317 epoxy resins, crosslinking agents and adjuncts may be safely used as food-contact surfaces and conform to listing in section 175.105, Title 21 (21 CFR 175.105) of the Code of Federal Regulations. The cured Hernon 317 epoxy coating may be applied over a metal or other suitable substrate as a continuous film that serves as a functional barrier between food and the substrate. Please review the regulations. Call 866-554-4005 (toll-free) or 407-322-4000 for more information about Hernon 317 two-part epoxy