Products tagged with ''

The Sureshot® 2200 Series dispensing valve systems accurately control the application of most low to medium viscosity fluids. The unique seal-less design incorporates an inert polymer diaphragm that isolates the actuator from the valve. Valve open time can be as short as 15 milli-seconds. The adjustable open/close stroke 0.025 to 0.76mm (0.001” to 0.030”) means very fast response and positive shutoff. Sureshot® 2200 series dispensing valves are used for dispensing adhesives and sealants including ultraviolet curing polymers, anaerobics, cyanoacrylates, as well as lubricants and fluxes. An ultra violet light blocking Delrin® valve manifold with optional UV kit # 110-030 on the Sureshot® 2200 provides consistent trouble free dispensing of U.V. curing polymers.

The Autosealer® 2650 is a control unit for applying sealant to pipe thread nipples, using either the Sureshot® 2200 or 4000 dispensing valves. The Autosealer® 2650 can be triggered manually with a footswitch and/or PLC/HMI color touchscreen button.

Designed to apply materials to recessed openings, the RotoCoater® evenly coats the inner surface of bores and other interior spaces. The unit can apply a controlled bead as well. The RotoCoater® 750 uses a bigger and more powerful air motor than the 500 to spin a larger dispersion cup which is inserted into a recessed area. The attached Sureshot® valve then delivers a metered amount of material to the cup that evenly coats the inner surface of the bore. The dispersion cup prevents overspray and applies a uniform layer of material. The RotoCoater® can be used with a wide-range of adhesives, sealants, oil or just about any liquid material. Each RotoCoater® 750 is customized for each application. Complete systems can be designed that apply materials to multiple bores in one cycle simultaneously.

Reservoir R-100 Assembly For AS5220 Machine

This foot/hand switch assembly connects to Hernon control boxes to trigger dispensing.

The R125 is a durable one gallon pressure reservoir is specifically designed for today’s production environment. The material output line is located in the center of the lid. This allows the dip tube to be centrally located so that an up to 1-gallon container can be directly placed into the reservoir. The lid design and single knob secure system permit quick changes or refills by operators and minimal clean up. The durable polyethylene material feed tube is resistant to most chemicals including adhesives, solvents, lubricants and sealants. The polyethylene feed tube is disposable and can be easily replaced. The material to be dispensed will only be in contact with the container and feed line.